Intake Manifold: Disassembly

WARNING: This page is about a different variant/trim than selected.

Remove the engine harness from intake manifold.
Remove the throttle body. <Ref. to REMOVAL , Throttle Body .>
Remove the pressure regulator vacuum hose from the intake manifold.

Fig 1: Locating Pressure Regulator Vacuum Hose And Intake Manifold
Courtesy of SUBARU OF AMERICA, INC.
Remove the manifold absolute pressure sensor. <Ref. to REMOVAL , Manifold Absolute Pressure Sensor .>
Remove the purge control solenoid valve. <Ref. to REMOVAL , Purge Control Solenoid Valve .>
Loosen the clamp which holds fuel injector pipe to the fuel hose, and then disconnect the pipe from fuel hose.

Fig 2: Locating Fuel Injector Pipe To Fuel Hose And Clamp
Courtesy of SUBARU OF AMERICA, INC.
Remove the bolts which install fuel pipes on intake manifold.

Fig 3: Locating Fuel Pipes, Intake Manifold And Bolts
Courtesy of SUBARU OF AMERICA, INC.

Fig 4: Locating Intake Manifold And Bolts
Courtesy of SUBARU OF AMERICA, INC.