FixVault
Home › Subaru › 2007 › Outback i, Automatic › Repair and Diagnosis › External Pages › Different car › Section 52 (Security And Locks) › Impact Sensor › Removal

Impact Sensor: Removal

WARNING: This page is about a different car, the 2006 Subaru Outback and 2006 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the key from ignition switch.
  2. Close all the doors, trunk lid and rear gate.
  3. Press the UNLOCK button of the keyless transmitter.
  4. Change the setting of impact sensor using Subaru Select Monitor.
  5. Disconnect the ground cable from battery.
  6. Remove the impact sensor.
About FixVault