FixVault
Home › Subaru › 2007 › Outback i, Standard › Repair and Diagnosis › External Pages › Different variant/trim › Section 15 (Engine Controls (Diagnostics) (H6DO)) › Subaru Select Monitor › Operation › Led Operation Mode For Engine

Led Operation Mode For Engine

WARNING: This page is about a different variant/trim than selected.
  1. On the «Main Menu» display screen, select {Each System Check}.
  2. On the «System Selection Menu» display screen, select {Engine Control System}.
  3. Select the [OK] after the information of engine type has been displayed.
  4. On the «Engine Diagnosis» display screen, select the {Current Data Display/Save}.
  5. On the «Data Display» screen, select the {Data LED Display}.
  6. Using the scroll key, scroll the display screen up or down until the desired data is shown.
    • A list of the support data is shown in the following table.
    SUPPORT DATA CHART

    Contents Display Message When LED "ON" is required
    Test mode signal Test mode terminal D check/U check D check
    Neutral position switch signal Neutral SW Neutral/Other than neutral Neutral
    Idle switch signal Soft Idle SW Idle/Other than idle At idle
    Ignition switch signal Ignition SW ON Input/OFF Input ON input
    Power steering switch signal Power steering SW ON Input/OFF Input ON input
    Air conditioning switch signal A/C SW ON Input/OFF Input ON input
    Starter switch signal Starter SW ON Input/OFF Input ON input
    Front oxygen monitor 1 FtO2 monitor 1 Lean/Rich Rich
    Front oxygen monitor 2 FtO2 monitor 2 Lean/Rich Rich
    Knocking signal Knock Signal Yes/No Yes
    Crankshaft position sensor signal Crankshaft angle signal Yes/No Yes
    Camshaft position sensor signal Camshaft angle signal Yes/No Yes
    Rear defogger switch signal Rear Defogger SW ON Input/OFF Input ON input
    Blower fan switch signal Blower fan SW ON Input/OFF Input ON input
    Light switch signal Light SW ON Input/OFF Input ON input
    Air conditioning lock signal A/C lock signal ON Input/OFF Input ON input
    A/C middle pressure switch signal A/C middle pressure SW ON Input/OFF Input ON input
    Air conditioner compressor relay signal Compressor relay ON output/OFF output ON output
    Pressure control solenoid valve signal PCV Solenoid ON or OFF When pressure control valve is ON.
    Drain valve signal Vent Control Solenoid ON or OFF When drain valve is ON.
    AT retard angle demand signal AT retard angle demand Yes/No Yes
    AT fuel cut signal AT fuel cut Yes/No Yes
    VDC torque down prohibition output Torque down output ON/OFF Prohibition
    VDC torque down demand Torque down demand Yes/No Yes
    AT coordinate permission signal AT coordinate permission signal ON/OFF Permission
    Electronic throttle control motor relay signal ETC motor relay ON/OFF ON
    Stop light switch signal Stop SW ON Input/OFF Input ON input
    SET/COAST switch signal SET/CST SW ON Input/OFF Input ON input
    RESUME/ACCEL switch signal RES/ACC SW ON Input/OFF Input ON input
    Brake switch signal Brake SW ON Input/OFF Input ON input
    Main switch signal Main SW ON Input/OFF Input ON input
    Body integrated unit data reception Body Int. Unit Data Yes/No Yes
    Body integrated unit counter update Body Int. Unit Count Yes/No Yes
    Cruise control cancel switch signal CC Cancel SW ON Input/OFF Input ON input
    NOTE: For detailed operation procedure, refer to the "SUBARU SELECT MONITOR OPERATION MANUAL".
About FixVault