FixVault
Home › Subaru › 2007 › Outback i, Standard › Repair and Diagnosis › External Pages › Different variant/trim › Section 15 (Engine Controls (Diagnostics) (H6DO)) › Subaru Select Monitor › Operation › Read Current Data For Engine (Normal Mode)

Read Current Data For Engine (Normal Mode)

WARNING: This page is about a different variant/trim than selected.
  1. On the «Main Menu» display screen, select {Each System Check}.
  2. On the «System Selection Menu» display screen, select {Engine Control System}.
  3. Select the [OK] after the information of engine type has been displayed.
  4. On the «Engine Diagnosis» display screen, select the {Current Data Display/Save}.
  5. On the «Data Display Menu» screen, select {Data Display}.
  6. Using the scroll key, scroll the display screen up or down until the desired data is shown.
    • A list of the support data is shown in the following table.
    SUPPORT DATA CHART

    Contents Display Unit of measure Note (at idling)
    Engine load Engine load % 2.4%
    Engine coolant temperature signal Engine coolant temperature °C or °F >85°C or 185°F (After engine is warmed-up.)
    A/F correction 1 A/F Compensation 1 % -10% - +10%
    A/F learning 1 A/F learning 1 % -10% - +10%
    A/F correction 2 A/F Compensation 2 % -10% - +10%
    A/F learning 2 A/F learning 2 % -10% - +10%
    Intake manifold absolute pressure Intake manifold absolute pressure mmHg, kPa, inHg or psig 210 mmHg, 28 kPa, 8.3 inHg or 4.1 psig
    Engine speed signal Engine speed rpm 600 - 800 rpm (After engine is warmed-up.)
    Meter vehicle speed signal Meter vehicle speed km/h or MPH 0 km/h or 0 MPH
    Ignition timing signal Ignition timing deg 13 - 15 deg
    Intake air temperature signal Intake air temperature °C or °F (Ambient air temperature)
    Amount of intake air Amount of intake air g/s or lb/m 2.5 g/s - 5.0 g/s or 0.31 lb/m - 0.71 lb/m
    Throttle opening angle signal Throttle valve angle % 2%
    Front oxygen sensor voltage value 1 Front oxygen sensor voltage value 1 V 0.900 V
    Front oxygen sensor voltage value 2 Front oxygen sensor voltage value 2 V 0.900 V
    Battery voltage Battery Voltage V 12 - 13V
    Mass air flow voltage Mass air flow voltage V 1.2 - 1.3V
    Injection 1 pulse width Injection 1 pulse width ms 2.5 ms - 3.5 ms
    Injection 2 pulse width Injection 2 pulse width ms 2.5 ms - 3.5 ms
    Atmospheric pressure signal Atmosphere Pressure mmHg, kPa, inHg or psig (Atmosphere pressure)
    Intake manifold relative pressure intake manifold relative pressure mmHg, kPa, inHg or psig (Intake manifold absolute pressure - atmosphere pressure)
    Ignition learning value Learned Ignition Timing deg +0.0 deg
    Acceleration opening angle signal Acceleration opening angle % 0%
    Fuel temperature signal Fuel Temp. °C or °F +28°C or +82°F
    Radiator fan output Radiator fan output % 0% (Water temperature 90°C (194°F) when air conditioner is OFF)
    Purge control solenoid valve duty ratio CPC duty % 18%
    Fuel pump duty Fuel pump duty % 33%
    Variable valve timing advance angle amount R WT advance angle amount R deg +0 deg - +1 deg
    Variable valve timing advance angle amount L WT advance angle amount L deg +0 deg - +1 deg
    Oil flow control solenoid valve duty R OCV duty R % 9.4%
    Oil flow control solenoid valve duty L OCV duty L % 9.4%
    Oil flow control solenoid valve current R OCV current R mA 64 mA
    Oil flow control solenoid valve current L OCV current L mA 64 mA
    Front oxygen (A/F) sensor current value 1 A/F sensor current value 1 mA 0.0 mA
    Front oxygen (A/F) sensor current value 2 A/F sensor current value 2 mA 0.0 mA
    Front oxygen (A/F) sensor resistance value 1 A/F sensor resistance value 1 Ω 31 Ω
    Front oxygen (A/F) sensor resistance value 2 A/F sensor resistance value 2 Ω 31 Ω
    Front oxygen (A/F) sensor output lambda 1 A/F sensor output lambda 1 - 1.01
    Front oxygen (A/F) sensor output lambda 2 A/F sensor output lambda 2 - 1.01
    A/F correction 3 A/F Compensation 3 % 0% - 1%
    A/F learning 3 A/F learning 3 % 0.0%
    Throttle motor duty Throttle motor duty % -20% - +20%
    Throttle power supply voltage Throttle power supply voltage V (Battery voltage)
    Sub throttle sensor voltage Sub throttle sensor voltage V 1.4 V - 1.5 V
    Main throttle sensor voltage Main throttle sensor voltage V 0.62 V - 0.70 V
    Sub accelerator sensor voltage Sub acceleration sensor voltage V 1.0V - 1.2V
    Main accelerator sensor voltage Main acceleration sensor voltage V 0.9 V - 1.1 V
    Memory vehicle speed Memory vehicle speed km/h or MPH 0 km/h or 0 MPH
    A/F correction 4 A/F Compensation 4 % -1% - 1%
    A/F learning 4 A/F learning 4 % 0.0%
    Fuel level sensor resistance Fuel level resistance Ω 4 - 96 Ω
    Engine oil temperature Oil Temperature °C or °F ≥ 85°C or 185°F (After engine is warmed-up.)
    Oil switching solenoid valve duty R OSV duty R % 18.4%
    Oil switching solenoid valve duty L OSV duty L % 18.8%
    Oil switching solenoid valve current R OSV current R mA 192mA
    Oil switching solenoid valve current L OSV current L mA 192mA
    Lift mode of variable valve lift VVL Lift Mode - 1
    #1 cylinder roughness monitor #1 cylinder roughness monitor - 0
    #2 cylinder roughness monitor #2 cylinder roughness monitor - 0
    #3 cylinder roughness monitor #3 cylinder roughness monitor - 0
    #4 cylinder roughness monitor #4 cylinder roughness monitor - 0
    #5 cylinder roughness monitor #5 cylinder roughness monitor - 0
    #6 cylinder roughness monitor #6 cylinder roughness monitor - 0
    Knock sensor correction Knock correction deg 0 deg
    Fuel tank pressure signal Fuel Tank Pressure mmHg, kPa, inHg or psig 0 mmHg, 0 kPa, 0 inHg or 0 psig
    AT/MT identification AT Vehicle ID Signal - OFF
    Test mode terminal Test mode terminal - U check
    System operation check mode D-check Require Flag - OFF
    Test mode terminal Delivery Mode Connector - OFF
    Neutral position switch signal Neutral SW - Neutral
    Idle switch signal Soft Idle SW - At idle
    Ignition switch signal Ignition SW - ON input
    Power steering switch signal Power steering SW input signal - OFF input (when OFF)
    Air conditioning switch signal A/C SW - OFF input (when OFF)
    Starter switch signal Starter SW - OFF input
    Front oxygen monitor 1 Front oxygen monitor 1 - Rich, Lean
    Front oxygen monitor 2 Front oxygen monitor 2 - Rich, Lean
    Knocking signal Knock signal - None
    Crankshaft position sensor signal Crankshaft angle signal - Provided
    Camshaft position sensor signal Camshaft angle signal - Provided
    Rear defogger switch signal Rear Defogger SW - OFF input (when OFF)
    Blower fan switch signal Blower fan SW - OFF input (when OFF)
    Light switch signal Light SW - OFF input (when OFF)
    A/C lock signal A/C lock signal - OFF input
    A/C middle pressure switch signal A/C middle pressure SW - OFF input (when air conditioner is OFF)
    A/C compressor relay signal A/C compressor relay output - OFF output (when air conditioner is OFF)
    Pressure control solenoid valve signal PCV Solenoid - OFF output (when OFF)
    Drain valve signal Vent Control Solenoid - OFF output (when OFF)
    Variable valve lift diagnosis oil pressure switch signal 1 Oil Temperature SW1 - ON
    Variable valve lift diagnosis oil pressure switch signal 2 Oil Temperature SW2 - ON
    AT coordinate retard angle demand signal AT coordinate retard angle demand - None
    AT coordinate fuel cut demand signal AT coordinate fuel cut demand - None
    Vehicle dynamics control (VDC) torque down prohibition output VDC torque down prohibition output - Permission
    Vehicle dynamics control (VDC) torque down demand VDC torque down demand - None
    AT cooperative permission signal AT coordinate permission signal - Permission
    Electronic throttle control motor relay signal ETC motor relay - ON
    Clutch switch signal Clutch Switch - OFF (when clutch is OFF)
    Stop light switch signal Stop light SW - OFF (when brake is OFF)
    SET/COAST switch signal SET/COAST SW - OFF (when levers are not operated)
    RESUME/ACCEL switch signal RESUME/ACCEL SW - OFF (when levers are not operated)
    Brake switch signal Brake SW - OFF (when brake is OFF)
    Main switch signal Main SW - OFF (when levers are not operated)
    Body integrated unit data reception Body Int. Unit Data - ON
    Body integrated unit counter update Body Int. Unit Count - ON
    Cruise control cancel switch signal CC Cancel SW - OFF (when levers are not operated)
    Malfunction indicator light flag MIL Lit Flag - Light OFF
About FixVault