Extension Case: Installation

Apply vase line to the selected thrust needle bearing, and install to the reduction drive gear end surface. < Ref. to ADJUSTMENT , Transfer Clutch.>
NOTE: Install the thrust needle bearing in the correct direction.
Install a new gasket.
Install the extension case to transmission case.
Tighten bolts to secure the extension case.
Tightening torque:

25 N.m (2.5 kgf-m, 18.4 ft-lb)

Fig 1: Installing Extension Case To Transmission Case
Courtesy of SUBARU OF AMERICA, INC.
Install the rear vehicle speed sensor.
Tightening torque:

7 N.m (0.7 kgf-m, 5.1 ft-lb)
- MP-T MODEL
  
  Fig 2: Installing Rear Vehicle Speed Sensor (MP-T MODEL)
  Courtesy of SUBARU OF AMERICA, INC.
- VTD MODEL
  
  Fig 3: Installing Rear Vehicle Speed Sensor (VTD MODEL)
  Courtesy of SUBARU OF AMERICA, INC.
Install the transmission assembly.
< Ref. to INSTALLATION , Automatic Transmission Assembly.>