FixVault
Home › Subaru › 2008 › Outback Base, Automatic › Repair and Diagnosis › Accessories & Equipment › Headlights › Lighting System › Combination Base Switch Assembly › Removal

Combination Base Switch Assembly: Removal

  1. Remove the driver's airbag module. <Ref. to REMOVAL , Driver's Airbag Module .>
  2. Remove the steering wheel. <Ref. to REMOVAL , Steering Wheel .>
  3. Remove the screws and remove the steering column lower cover.
    Fig 1: Locating Steering Column Lower Cover Screws
    G05022834Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the combination switch. <Ref. to REMOVAL , Combination Switch (Light) .> <Ref. to REMOVAL , Combination Switch (Wiper) .>
  5. Remove the four screws and remove the roll connector.
  6. Remove the three screws.
    Fig 2: Locating Combination Switch Screws
    G05004089Courtesy of SUBARU OF AMERICA, INC.
  7. Disconnect the connector and remove the combination base switch assembly.
About FixVault