Read Current Data
WARNING: This page is about a different car, the 2007 Subaru Outback and 2007 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
- On the «Main Menu» display screen, select the {Each System Check}.
- On the «System Selection Menu» display screen, select the {Brake Control}.
- Select the [OK] after {ABS} is displayed.
- On the «Brake Control Diagnosis» display screen, select the {Current Data Display/Save}.
- On the «Display Menu» screen, select the data display method.
- Using the scroll key, scroll the display screen up or down until necessary data is shown.
- A list of the support data is shown in the following table.SUPPORT DATA
Display Contents to be monitored Unit of measure FR Wheel Speed Wheel speed detected by front ABS wheel speed sensor RH is displayed. km/h or MPH FL Wheel Speed Wheel speed detected by front ABS wheel speed sensor LH is displayed. km/h or MPH RR Wheel Speed Wheel speed detected by rear ABS wheel speed sensor RH is displayed. km/h or MPH RL Wheel Speed Wheel speed detected by rear ABS wheel speed sensor LH is displayed. km/h or MPH BLS Signal Brake ON/OFF is displayed. ON or OFF G Sensor Vehicle acceleration detected by analog G sensor is displayed. m/s (m/s2) Valve Relay Signal Valve relay operation signal is displayed. ON or OFF ABS Warning Light ON operation of the ABS warning light is displayed. ON or OFF EBD Warning Light ON operation of the EBD warning light is displayed. ON or OFF Motor Relay Monitor Motor relay monitor voltage is displayed. V IG Power Supply Voltage Voltage supplied to ABSCM&H/U is displayed. V ABS Control Flag ABS control condition is displayed. ON or OFF ABS OK B Signal ABS system normal/abnormal is displayed. OK or NG NOTE: For details concerning operation procedures, refer to the "SUBARU SELECT MONITOR OPERATION MANUAL".