FixVault
Home › Subaru › 2008 › Outback Base, Automatic › Repair and Diagnosis › External Pages › Different car › Section 136 (Anti-Lock Brake System (Abs)) › Front ABS Wheel Speed Sensor › Inspection › Abs Wheel Speed Sensor

Abs Wheel Speed Sensor

WARNING: This page is about a different car, the 2007 Subaru Outback and 2007 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check the tip of the ABS wheel speed sensor for foreign particles or damage. If necessary, clean the tip or replace the ABS wheel speed sensor.
  2. Connect a 12 V power supply to No. 2 terminal of sensor connector as shown in the figure, then attach resistance to the No. 1 terminal. Rotate the wheel at about 2.75 km/h (2 MPH), and measure the voltage using an oscilloscope.

    Standard value of output voltage: 

    0.7 - 1.4 V 

    Fig 1: Checking ABS Wheel Speed Sensor
    G05020216Courtesy of SUBARU OF AMERICA, INC.
    NOTE: Check the ABS wheel speed sensor cable for discontinuity. If necessary, replace with a new part.
About FixVault