Section 21 (Clutch System): Flywheel: Installation

WARNING: This page is about a different car, the 2006 Subaru Outback and 2006 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The illustration below is for a Turbo model. However, perform the same procedures for the Non-turbo model.

Install the flywheel and ST.
ST 498497100 CRANKSHAFT STOPPER

Fig 1: Installing Flywheel And ST (498497100)
Tighten the flywheel mounting bolts to the specified torque.
ST 499057000 TORX® PLUS

NOTE: Tighten the flywheel attachment bolts gradually.
Each bolt should be tightened to the specified torque in crisscross order.

Tightening torque:

72 N.m (7.3 kgf-m, 52.8 ft-lb)

Fig 2: Tightening Sequence Of Flywheel Bolts
Install the clutch disc and cover. < Ref. to INSTALLATION , Clutch Disc and Cover. >
Install the transmission assembly. < Ref. to INSTALLATION , Manual Transmission Assembly. >