Clear Memory Mode

WARNING: This page is about a different variant/trim than selected.

Check that the select lever is in "P" range.
On the «Main Menu», select {Each System Check}.
On the «System Selection Menu», select {Transmission}.
After transmission type information pops up, select [OK].
On the «Transmission Diagnosis», select {Clear Memory}.
When the "Done. Turn ignition switch to OFF" pops up, select [OK].
Turn Subaru Select Monitor and ignition switch to OFF. To turn the ignition switch to ON again, wait for 10 seconds or more.

NOTE:

To clear the previous DTC, use {Clear Memory}, and to clear the learned value, use {Clear Memory 2}.
If {Clear Memory 2} is selected and performed, DTC are not cleared.
For details concerning the operation procedure, refer to the «help on PC application for Subaru Select Monitor».