FixVault
Home › Subaru › 2008 › Outback Base, Automatic › Repair and Diagnosis › Suspension › Wheel Alignment › Rear Suspension System › Rear Arm › Assembly › Rear Bushing

Rear Bushing

  1. Insert the bushing into the bore of ST D.
  2. Set the ST C, ST D and bearing puller in the specified positions as shown in the figure, and then press-fit the bushing until the outer end of bushing and rear end of rear arm is flat.

    ST C 20099AE040 INSTALLER & REMOVER SET

    ST D 20099AE040 INSTALLER & REMOVER SET

    Fig 1: Pressing Bushing Into Trailing Link
    G05342896Courtesy of SUBARU OF AMERICA, INC.
About FixVault