Clear Memory Mode

Check that the select lever is in "P" range.
On the «Main Menu», select {Each System Check}.
On the «System Selection Menu», select {Transmission}.
After transmission type information pops up, select [OK].
On the «Transmission Diagnosis», select {Clear Memory}.
When the "Done. Turn ignition switch to OFF" pops up, select [OK].
Turn Subaru Select Monitor and ignition switch to OFF. To turn the ignition switch to ON again, wait for 10 seconds or more.
NOTE:
- If {Clear Memory 2} is selected and performed, DTC and learned control memory are cleared. If {Clear Memory 2} is performed, perform learning control promotion. < Ref. to FACILITATION OF LEARNING CONTROL , OPERATION, Subaru Select Monitor . >
- For details concerning the operation procedure, refer to the "help on PC application for Subaru Select Monitor".