FixVault
Home › Subaru › 2008 › Outback Base, Standard › Repair and Diagnosis › External Pages › Different car › Section 114 (Airbag System) › Roll Connector › Removal

Roll Connector: Removal

WARNING: This page is about a different car, the 2007 Subaru Outback and 2007 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch to OFF.
  2. Disconnect the ground cable from battery and wait for at least 20 seconds before starting work.
  3. Remove the driver's airbag module. <Ref. to REMOVAL , Driver's Airbag Module .>
  4. Remove the steering wheel. <Ref. to REMOVAL , Steering Wheel .>
  5. Remove the steering column cover.
  6. Remove the screws, and then remove the roll connector.
    Fig 1: Locating Roll Connector Screws
    G05020508Courtesy of SUBARU OF AMERICA, INC.
About FixVault