FixVault
Home › Subaru › 2008 › Outback Base, Standard › Repair and Diagnosis › External Pages › Different car › Section 121 (Vehicle Dynamics Control (VDC)) › VDC Sequence Control › Operation › VDC Sequence Control With SUBARU Select Monitor

VDC Sequence Control With SUBARU Select Monitor

WARNING: This page is about a different car, the 2007 Subaru Outback and 2007 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: In the event of any trouble, sequence control will not operate.
  1. Connect the Subaru Select Monitor to data link connector under the driver's side instrument panel lower cover.
  2. Turn the ignition switch to ON.
  3. Run the Subaru Select Monnitor.
  4. Set the Subaru Select Monitor to "Brake Control" mode.
  5. When the "VDC Inspection Mode" is selected from the "Function check sequence" menu, the "VDC sequence control" will start.
  6. "Select the [OK]" will be displayed. Select the [OK].
  7. Operation points will be displayed on Subaru Select Monitor.
About FixVault