Transmission Control Device: Installation

WARNING: This page is about a different car, the 2007 Subaru Outback and 2007 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

Install the detention spring to the transmission case.
Tightening torque:

6 N.m (0.6 kgf-m, 4.4 ft-lb)

Fig 1: Identifying Detent Spring
Courtesy of SUBARU OF AMERICA, INC.
Insert the select lever, and then tighten the bolt.
Tightening torque:

6 N.m (0.6 kgf-m, 4.4 ft-lb)

Fig 2: Identifying Range Select Lever And Bolt
Courtesy of SUBARU OF AMERICA, INC.
Insert the manual plate and parking rod.

Fig 3: Identifying Manual Plate And Parking Rod
Courtesy of SUBARU OF AMERICA, INC.
Insert the spring pin to the manual plate.

Fig 4: Identifying Spring Pin To Manual Plate
Courtesy of SUBARU OF AMERICA, INC.
Install the oil pan and the control valve assembly. < Ref. to INSTALLATION , Control Valve Body. >
Install the pitching stopper bracket.
Tightening torque:

41 N.m (4.2 kgf-m, 30.4 ft-lb)
Insert the transmission connector to the stay.
Install the air breather hose. < Ref. to INSTALLATION , Air Breather Hose. >
Install the torque converter assembly. < Ref. to INSTALLATION , Torque Converter Assembly. >
Install the transmission assembly to the vehicle. < Ref. to INSTALLATION , Automatic Transmission Assembly. >