FixVault
Home › Subaru › 2008 › Outback Base, Standard › Repair and Diagnosis › External Pages › Different car › Section 31 (LAN System (Diagnostics)) › Subaru Select Monitor › Operation › Read Current Data

Read Current Data

WARNING: This page is about a different car, the 2006 Subaru Outback, 2006 Subaru Legacy, and 2006 Saab 9-2X. However, it is still accessible from the selected car via links, so may be relevant.
  1. On the «Main Menu» display screen, select {Each System Check} and press the [YES] key.
  2. On the «System Selection Menu» display screen, select the {Integ. unit mode} and press the [YES] key.
  3. On the «Integ. unit mode failure diag» display screen, select the {Current Data Display & Save} and press the [YES] key.
  4. On the «Current Data Display & Save» display screen, select the {12 Data Display} and press the [YES] key.
  5. Using the scroll key, scroll the display screen up or down until the desired data is shown.

A support list contains both of analog and digital data, and they are shown in the following table.

About FixVault