Rear Vehicle Speed Sensor: Installation

WARNING: This page is about a different variant/trim than selected.

Install the rear vehicle speed sensor.
Tightening torque:

7 N.m (0.7 kgf-m, 5.2 ft-lb)

Fig 1: Identifying Rear Vehicle Speed Sensor
Courtesy of SUBARU OF AMERICA, INC.
Connect the rear vehicle speed sensor connector.

Fig 2: Identifying Rear Vehicle Speed Sensor Connector
Courtesy of SUBARU OF AMERICA, INC.
Install the transmission rear crossmember bolt.
Tightening torque:

75 N.m (7.6 kgf-m, 55.3 ft-lb)
Install the propeller shaft. < Ref. to INSTALLATION , Propeller Shaft. >
Install the heat shield cover.

Fig 3: Identifying Heat Shield Cover
Courtesy of SUBARU OF AMERICA, INC.
Install the center, rear exhaust pipes and the muffler. (Turbo model)
< Ref. to INSTALLATION , Center Exhaust Pipe . > < Ref. to INSTALLATION , Rear Exhaust Pipe . > < Ref. to INSTALLATION , Muffler . >
Install the rear exhaust pipe and muffler. (Non-turbo model) < Ref. to INSTALLATION , Rear Exhaust Pipe. > < Ref. to INSTALLATION , Muffler. >
Lower the vehicle.
Pour ATF from the oil charge pipe. < Ref. to REPLACEMENT , Automatic Transmission Fluid. >
Check the level and leaks of ATF. < Ref. to INSPECTION , Automatic Transmission Fluid. >