FixVault
Home › Subaru › 2008 › Outback XT Limited, Automatic › Repair and Diagnosis › Transmission › Automatic Trans › Automatic Transmission (Diagnostics) (5AT) › Learning Control › Procedure › Driving Learning

Driving Learning

  1. Start the engine.
  2. Connect Subaru Select Monitor to the vehicle, and select {Normal sampling} on the «Current Data Display & Save» screen.
  3. Drive the vehicle for 5 - 10 km (3 - 6 miles) to warm up ATF temperature to be 60°C (140°F) or more.
  4. Shift the SI-DRIVE selector to "S" mode.
  5. While checking that the throttle opening angle on Subaru Select Monitor is within the specified range, shift the gear from 1st → 2nd, 2nd → 3rd, 3rd → 4th, and 4th → 5th, while driving the vehicle at "D" range. < Ref. to READ CURRENT DATA , OPERATION, Subaru Select Monitor. >

    Acceleration opening angle: 30% or more 

  6. Repeat the step  5) until the reducing effect of the shifting shock is felt.
  7. If reducing of shifting shock is not felt after performing the cycle described in step  5), recheck that the learning conditions (throttle opening angle, ATF temperature, etc.) are as specified, and recheck that other parts are normal.
About FixVault