FixVault
Home › Subaru › 2008 › Outback XT Limited, Automatic › Repair and Diagnosis › Transmission › Automatic Trans › Automatic Transmission (Diagnostics) (5AT) › Learning Control › Procedure › Simple Learning

Simple Learning

  1. Turn the ignition switch to ON (engine OFF).
  2. With the brake pedal depressed, shift the select lever to "R" range.
  3. Perform the {Clear Memory 2}. < Ref. to CLEAR MEMORY MODE , OPERATION, Subaru Select Monitor. >
  4. Turn the ignition switch to ACC without depressing the brake pedal.
  5. Depress and hold the brake pedal with left foot until step  17).
  6. Turn the ignition switch to ON.
  7. Select {Normal sampling} on the «Current Data Display & Save» screen of Subaru Select Monitor, and confirm that ATF oil temperature reaches 60 - 90°C (140 - 194°F).
  8. Shift the select lever to the "P" range, and wait for 3 seconds or more.
  9. Shift the select lever to the "R" range, and wait for 3 seconds or more.
  10. Shift the select lever to the "N" range, and wait for 3 seconds or more.
  11. Shift the select lever to the "D" range, and wait for 3 seconds or more.
  12. Shift the select lever to the "N" range, and wait for 3 seconds or more.
  13. Slowly depress the accelerator pedal to full throttle.
  14. Slowly release the accelerator pedal to full close.
  15. Start the engine, and idle it.
  16. Shift the select lever to "D" range.
  17. Transmission simple learning starts. AT OIL TEMP light in the combination meter illuminates. (Parking brake mark is displayed on the multi-information display, but it is normal.) If AT OIL TEMP light does not illuminate, repeat the simple learning from step  1) again.
  18. Confirm that the AT OIL TEMP light in the combination meter illuminates and that buzzer sounds at 2 Hz, and then release the brake pedal. (After the brake pedal is released, the buzzer will continue to sound for a while and the AT OIL TEMP light will blink.)
  19. Confirm that the AT OIL TEMP light in the combination meter illuminates and that buzzer sounds at 2 Hz, and then depress the brake pedal with left foot. (After the brake pedal is depressed, the buzzer will continue to sound for a while and the AT OIL TEMP light will blink.)
  20. Make sure that buzzer sounds at 2 Hz, and shift the select lever to "R" range.
  21. The simple learning completes normally if the AT OIL TEMP light in the combination meter goes off. If the blinking of the AT OIL TEMP light changes from 2 Hz to 4 Hz, repeat the simple learning from step  1) again.
  22. Shift the select lever to "P" range, turn the ignition switch to OFF, and then leave it for 30 minutes or more.
  23. Lower the vehicle.
About FixVault