Fuel Delivery & Evaporation Lines: Installation

Connect the quick connector on fuel line.
CAUTION: Make sure that the connected portion is not damaged or has dust. If necessary, clean seal surface of pipe.

NOTE: Always use a new retainer except in use of engine compartment.

Fig 1: Identifying Seal Surface And Pipe
Courtesy of SUBARU OF AMERICA, INC.
1. Set the new retainer (B) to connector (A).
2. Push the pipe into the connector completely.
  
  Fig 2: Setting Retainer To Pipe
  Courtesy of SUBARU OF AMERICA, INC.
  CAUTION:
  - Pull the connector to ensure it is connected securely.
  - Make sure the two retainer pawls are engaged in their mating positions in the connector.
  - Be sure to inspect the hoses and their connections for fuel leakage.
    
    Fig 3: Checking Connector Connections
    Courtesy of SUBARU OF AMERICA, INC.
Connect the fuel delivery hose to the pipe with an overlap of 20 to 25 mm (0.79 to 0.98 in).
Type A: When the amount of inserting is specified.

Type B: When the amount to be inserted is not specified.

L1:2.5±1.5 mm (0.098±0.059 in)

L2:22.5±2.5 mm (0.886±0.098 in)

Fig 4: Identifying L1 And L2 Dimensions
Courtesy of SUBARU OF AMERICA, INC.
Connect the evaporation hose to the pipe with an overlap of 15 to 20 mm (0.59 to 0.79 in).
L: 17.5±2.5 mm (0.689±0.098 in)

CAUTION: Be sure to inspect the hoses and their connections for fuel leakage.

Fig 5: Identifying Evaporation Hose Connection
Courtesy of SUBARU OF AMERICA, INC.