Yaw Rate and Lateral G Sensor: Installation
Install in the reverse order of removal.
Tightening torque:
7.5 N.m (0.76 kgf-m, 5.5 ft-lb)
CAUTION:
After completion of installation, set the following two positions.
The procedures above are required for the VDCCM & H/U to identify the vehicle position later. For the setting procedures of the two steps above, refer to "VDC Control Module and Hydraulic Control Unit (VDCCM & HAJ)". Refer to ADJUSTMENT , VDC Control Module and Hydraulic Control Unit (VDCCM & H/U).
- Positioning to the center of steering angle sensor
- Positioning of the yaw rate & lateral G sensor to zero
The procedures above are required for the VDCCM & H/U to identify the vehicle position later. For the setting procedures of the two steps above, refer to "VDC Control Module and Hydraulic Control Unit (VDCCM & HAJ)". Refer to ADJUSTMENT , VDC Control Module and Hydraulic Control Unit (VDCCM & H/U).