FixVault
Home › Subaru › 2009 › Forester XT › Repair and Diagnosis › Transmission › Automatic Trans › Automatic Transmission 4AT (Diagnostics) › Subaru Select Monitor › Operation

Subaru Select Monitor: Operation

  1. Prepare the Subaru Select Monitor kit.
    2. Fig 1: Identifying Subaru Select Monitor Kit
    G05658482Courtesy of SUBARU OF AMERICA, INC.
  2. Prepare PC with Subaru Select Monitor installed.
  3. Connect the SDI (Subaru Diagnostic Interface) to the PC USB port (exclusively for Subaru Selector Monitor) using a USB cable.
    NOTE: Port exclusively for Subaru Select Monitor refers to the USB port used when installing Subaru Select Monitor.
  4. Connect the diagnosis cable to SDI.
  5. Connect the SDI to data link connector located in the lower portion of the instrument panel (on the driver's side).
    Fig 2: Locating Data Link Connector In Lower Portion Of Instrument Panel (On Driver's Side)
    G05660150Courtesy of SUBARU OF AMERICA, INC.
    CAUTION: Do not connect the scan tools other than the Subaru Select Monitor.
  6. Start the PC.
  7. Turn the ignition switch to ON.
  8. Run the "PC application for Subaru Select Monitor".
About FixVault