Knock Sensor: Installation

Install the knock sensor to the cylinder block.
NOTE: The portion of the knock sensor cord that is pulled out must be positioned at a 60° angle relative to the engine rear.

Tightening torque: 24 N.m (2.4 kgf-m, 17.7 ft-lb)

Fig 1: Locating Knock Sensor To Cylinder Block And Bolt Angle
Courtesy of SUBARU OF AMERICA, INC.
Connect the knock sensor connector.

Fig 2: Identifying Knock Sensor Connector
Courtesy of SUBARU OF AMERICA, INC.
Install the intercooler. Refer to INSTALLATION , Intercooler.
Connect the ground cable to battery.

Fig 3: Identifying Battery Ground Cable

Courtesy of SUBARU OF AMERICA, INC.