FixVault
Home › Subaru › 2009 › Outback Limited › Repair and Diagnosis › Brakes › Traction Control › Vehicle Dynamics Control (VDC) (Diagnostics) › Subaru Select Monitor › Operation › How To Use SUBARU Select Monitor

How To Use SUBARU Select Monitor

  1. Prepare the Subaru Select Monitor kit. Refer to SPECIAL TOOL , PREPARATION TOOL, General Description.
    Fig 1: Identifying Subaru Select Monitor Kit
    G05658482Courtesy of SUBARU OF AMERICA, INC.
  2. Prepare PC with Subaru Select Monitor installed.
  3. Connect the USB cable between SDI (Subaru Diagnosis Interface) and USB port on the personal computer (dedicated port for the Subaru Select Monitor).
    NOTE: The dedicated port for the Subaru Select Monitor means the USB port which was used to install the Subaru Select Monitor.
  4. Connect the diagnosis cable to SDI.
  5. Connect SDI to data link connector located in the lower portion of the instrument panel (on the driver's side).
    Fig 2: Identifying Data Link Connector
    G06339350Courtesy of SUBARU OF AMERICA, INC.
    CAUTION: Do not connect scan tools other than the Subaru Select Monitor.
  6. Start the PC.
  7. Turn the ignition switch to ON (engine OFF) and run the "PC application for Subaru Select Monitor".
    NOTE: For detailed operation procedure, refer to the "Subaru Select Monitor ".
  8. If VDC and Subaru Select Monitor cannot communicate, check the communication circuit. Refer to COMMUNICATION FOR INITIALIZING IMPOSSIBLE , INSPECTION, Subaru Select Monitor.
About FixVault