FixVault
Home › Subaru › 2009 › Outback Limited › Repair and Diagnosis › External Pages › Different variant/trim › Section 10 (Clutch System) › Release Bearing and Lever › Installation › 5MT Model

5MT Model

WARNING: This page is about a different variant/trim than selected.
NOTE: Apply the specified grease to lubricate the following points before installation.
  • Contact surface of lever and pivot
  • Contact surface of lever and bearing
  • Transmission main shaft spline (Use grease containing molybdenum disulfide.)
  1. While pushing the release lever to the pivot and twisting it to both sides, fit the lever spring onto the raised portion of the pivot.
    NOTE:
    • Apply grease (KOPR-KOTE: Part No. 003603001) to the contact point of the release lever and operating cylinder.
    • Observing from the main case hole, check that the lever spring is installed securely.
      Fig 1: Fitting Lever Spring Onto Raised Portion Of Pivot
      G06338598Courtesy of SUBARU OF AMERICA, INC.
  2. Install the release bearing and fasten it with two clips. (Non-turbo model)
  3. Install the release bearing. (Turbo model)
  4. Install the dust cover.
    Fig 2: Identifying Release Lever And Dust Cover
    G06338599Courtesy of SUBARU OF AMERICA, INC.
  5. Check the bearing for smooth movement by operating the release lever.
  6. Install the transmission assembly. Refer to INSTALLATION , Manual Transmission Assembly.
About FixVault