FixVault
Home › Subaru › 2009 › Tribeca Base › Repair and Diagnosis › Brakes › Traction Control › Vehicle Dynamics Control (VDC) (Diagnostics) › Subaru Select Monitor › Operation › How To Use SUBARU Select Monitor

How To Use SUBARU Select Monitor

  1. Prepare the Subaru Select Monitor kit. Ref. to SPECIAL TOOL , PREPARATION TOOL, General Description.
    Fig 1: Identifying Subaru Select Monitor Kit
    G05658482Courtesy of SUBARU OF AMERICA, INC.
  2. Prepare PC with Subaru Select Monitor installed.
  3. Connect the USB cable to the SDI (Subaru Diagnostic Interface) and the USB port of the personal computer (port for Subaru Select Monitor).
    NOTE: The dedicated port for the Subaru Select Monitor means the USB port which was used to install the Subaru Select Monitor.
  4. Connect the diagnosis cable to SDI.
  5. Connect the SDI to the data link connector located in the lower portion of the instrument panel (on the driver's side).
    Fig 2: Identifying Data Link Connector
    G05664733Courtesy of SUBARU OF AMERICA, INC.
    CAUTION: Do not connect scan tools other than the Subaru Select Monitor.
  6. Start the PC.
  7. Turn the ignition switch to ON (engine OFF) and run the "PC application help for Subaru Select Monitor".
    NOTE: For detailed operation procedure, refer to SUBARU SELECT MONITOR .
  8. If VDC and Subaru Select Monitor cannot communicate, check the communication circuit. Ref. to COMMUNICATION FOR INITIALIZING IMPOSSIBLE , INSPECTION, Subaru Select Monitor.
About FixVault