Starting System & Charging System (H6DO): Starter: Disassembly

Loosen the nut which holds terminal M (A) of the magnet switch assembly, then disconnect the harness from the terminal.

Fig 1: Identifying Terminal M
Courtesy of SUBARU OF AMERICA, INC.
Remove the nuts holding the magnet switch assembly, and remove the magnet switch assembly.

Fig 2: Locating Magnet Switch Assembly Nuts
Courtesy of SUBARU OF AMERICA, INC.
Remove the starter seal.

Fig 3: Identifying Starter Seal
Courtesy of SUBARU OF AMERICA, INC.
Remove the through bolts on both sides, and then remove the starter housing.

Fig 4: Locating Starter Housing Bolts
Courtesy of SUBARU OF AMERICA, INC.

Fig 5: Identifying Starter Housing
Courtesy of SUBARU OF AMERICA, INC.
Remove the shift lever.

Fig 6: Removing/Installing Shift Lever
Courtesy of SUBARU OF AMERICA, INC.
Remove the overrunning clutch, shock absorber bearing and shaft from the yoke as an assembly.

Fig 7: Removing/Installing Overrunning Clutch, Shock Absorber Bearing And Shaft
Courtesy of SUBARU OF AMERICA, INC.
Remove the overrunning clutch from shaft assembly as follows:
1. Using a plastic hammer, remove the stopper from snap ring by lightly tapping the stopper with an appropriate tool (such as a fit socket wrench).
  
  Fig 8: Tapping Stopper And Snap Ring
  Courtesy of SUBARU OF AMERICA, INC.
2. Remove the snap ring (A) from the shaft, and then remove the stopper (B).
  
  Fig 9: Removing/Installing Snap Ring
  Courtesy of SUBARU OF AMERICA, INC.
3. Remove the overrunning clutch from the shaft.
  
  Fig 10: Removing/Installing Overrunning Clutch
  Courtesy of SUBARU OF AMERICA, INC.
Remove the shock absorber as follows:
1. Remove the starter plate.
  
  Fig 11: Identifying Starter Plate
  Courtesy of SUBARU OF AMERICA, INC.
2. Remove the planetary gear.
  
  Fig 12: Identifying Planetary Gear
  Courtesy of SUBARU OF AMERICA, INC.
3. Remove the snap ring, and then remove the shaft.
  
  Fig 13: Removing/Installing Snap Ring
  Courtesy of SUBARU OF AMERICA, INC.
  
  Fig 14: Removing/Installing Shaft
  Courtesy of SUBARU OF AMERICA, INC.
4. Separate the shock absorber bearing (A) from the internal gear (B), and then remove the shock absorber (C).
  
  Fig 15: Removing/Installing Shock Absorber Bearing
  Courtesy of SUBARU OF AMERICA, INC.
Remove the screws, and remove the starter cover from the brush holder assembly.
NOTE: Hold with the screw so that the brush holder assembly will remain on the armature side, and separate.

Fig 16: Identifying Starter Cover Screws
Courtesy of SUBARU OF AMERICA, INC.

Fig 17: Removing Starter Cover
Courtesy of SUBARU OF AMERICA, INC.
Remove the brush holder assembly from the armature by hand.
NOTE: Spread the brushes with your fingers, being careful not to damage them.

Fig 18: Removing/Installing Brush Holder Assembly
Courtesy of SUBARU OF AMERICA, INC.
Remove the armature from the yoke.

Fig 19: Removing/Installing Armature
Courtesy of SUBARU OF AMERICA, INC.