Basic Diagnostic Procedure: Procedure

CAUTION:

Subaru Select Monitor is required for reading DTC, performing diagnosis and reading current data.
Remove foreign matter (dust, water, oil, etc.) from the body integrated unit connector during removal and installation.
For model with immobilizer, registration of immobilizer is necessary after the replacement of control module, etc. For details, refer to the PC application help for Subaru Select Monitor.

NOTE:

To check harness for open or short circuits, shake the suspected trouble spot or connector.
Check List for Interview Ref. to CHECK LIST FOR INTERVIEW .

DIAGNOSTIC PROCEDURE

Step	Check	Yes	No
1 CHECK PRE-INSPECTION. Ask the customer when and how the trouble occurred using the interview check list. Ref. to CHECK LIST FOR INTERVIEW .	Did you interview the customer?	Go to step 2 .	Interview the customer.
2 BASIC INSPECTION. Check components which might affect body control. Ref. to INSPECTION , General Description.	Is the component that might influence the body control problem normal?	Go to step 3 .	Repair or replace each component.
3 CHECK DTC. Read the DTC. Ref. to OPERATION , Read Diagnostic Trouble Code (DTC). NOTE: If the communication function of the Subaru Select Monitor cannot be executed properly, check the communication circuit. Ref. to COMMUNICATION FOR INITIALIZING IMPOSSIBLE , Diagnostic Procedure with Diagnostic Trouble Code (DTC). Record all DTCs and freeze frame data.	Is DTC displayed on Subaru Select Monitor?	Go to step 5 .	Go to step 4 .
4 PERFORM GENERAL DIAGNOSTICS. Inspect using "General Diagnostics Table". Ref. to GENERAL DIAGNOSTIC TABLE .	Is result of inspection OK?	The body control system is normal.	Go to step 5 .
5 PERFORM DIAGNOSIS. Correct the cause of trouble. Perform the Clear Memory Mode. Ref. to OPERATION , Clear Memory Mode. Read the DTC. Ref. to OPERATION , Read Diagnostic Trouble Code (DTC).	Is DTC displayed on Subaru Select Monitor?	Repeat step 5 until DTC is not shown.	Finish the diagnosis.