General Scan Tool

After performing the diagnostics and clearing the memory, check that no DTC remains. Ref. to MODE $04 (CLEAR/RESET EMISSION-RELATED DIAGNOSTIC INFORMATION) , OPERATION, General Scan Tool.
Warm up the engine.
Install the delivery (test) mode fuse (A) of the main fuse box.

Fig 1: Identifying Delivery (Test) Mode Fuse Of Main Fuse Box
Courtesy of SUBARU OF AMERICA, INC.
Connect the general scan tool to the data link connector located in the lower portion of the instrument panel (on the driver's side).
CAUTION: Do not connect any scan tools except Subaru Select Monitor or general scan tool.

Fig 2: Locating Data Link Connector
Courtesy of SUBARU OF AMERICA, INC.
Start the engine.
NOTE:
- Make sure the select lever is placed in "P" position before starting. (CVT model)
- Depress the clutch pedal when starting engine. (MT model)
Turn the neutral position switch to ON operating select lever or shift lever.
Depress the brake pedal to turn the brake switch ON. (CVT model)
Keep the engine speed in 2,500 - 3,000 RPM range for 40 seconds.
Place the select lever or shift lever in "D" position (CVT model) or "1st gear" (MT model) and drive the vehicle at 5 to 10 km/h (3 to 6 MPH).
NOTE:
- For AWD model, release the parking brake.
- The speed difference between front and rear wheels may illuminate the ABS warning light, but this does not indicate a malfunction. When engine control system diagnosis is finished, perform the VDC memory clearance procedure of self-diagnosis system. Ref. to CLEAR MEMORY MODE .
Using the general scan tool, check for DTC and record the result(s).
NOTE:
- For detailed operation procedures, refer to the general scan tool operation manual. For details concerning DTC, refer to "List of Diagnostic Trouble Code (DTC)".
- Ref. to LIST OF DIAGNOSTIC TROUBLE CODE (DTC) .