Master Cylinder: Installation

WARNING: This page is about a different variant/trim than selected.

Install the master cylinder to the pedal assembly.
Tightening torque:

18 N.m (1.8 kgf-m, 13.3 ft-lb)

Fig 1: Identifying Master Cylinder To Pedal Assembly
Courtesy of SUBARU OF AMERICA, INC.
Connect the clutch pipes to the master cylinder.
Tightening torque:

15 N.m (1.5 kgf-m, 11.1 ft-lb)

Fig 2: Locating Clutch Stroke Sensor Connector
Courtesy of SUBARU OF AMERICA, INC.
Connect the clutch stroke sensor connector.
Connect the push rod of the master cylinder to the clutch pedal, and install the clevis pin and clip.
CAUTION: Always use a new clevis pin.

NOTE: Apply grease to the clevis pin.

Fig 3: Identifying Grease Applying Area
Courtesy of SUBARU OF AMERICA, INC.
Install the pedal assembly. Ref. to INSTALLATION , Clutch Pedal.
Install the instrument panel lower cover. Ref. to INSTALLATION , Instrument Panel Lower Cover.
Connect the ground cable to battery.
Fill the recommended clutch fluid. Ref. to CLUTCH FLUID .
After bleeding air from the clutch system, ensure that the clutch operates properly. Ref. to CLUTCH FLUID AIR BLEEDING .
Install the collector cover.
When the clutch master cylinder assembly has been replaced, perform the clutch sensor calibration mode. Ref. to CLUTCH SENSOR CALIBRATION MODE , OPERATION, Subaru Select Monitor.
NOTE: If necessary, perform the clutch meet position setting. Ref. to CLUTCH ENGAGEMENT POSITION SETTING , OPERATION, Subaru Select Monitor.