FixVault
Home › Subaru › 2010 › Outback Limited › Repair and Diagnosis › External Pages › Different variant/trim › Section 9 (Automatic Transmission) › Front Differential Assembly › Removal

Front Differential Assembly: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the transmission assembly from the vehicle. Ref. to REMOVAL , Automatic Transmission Assembly.
  2. Pull out the torque converter assembly. Ref. to REMOVAL , Torque Converter Assembly.
  3. Remove the transmission harness connector from stay.
  4. Remove the ATF inlet and outlet pipes. Ref. to REMOVAL , ATF Cooler Pipe and Hose.
  5. Separate the converter case from the transmission case. Ref. to REMOVAL , Converter Case.
  6. Remove the differential side retainers using ST.
    NOTE: Hold the differential case assembly by hand to avoid damaging the differential side retainer mounting hole of the converter case.

    ST 18630AA010 WRENCH COMPL RETAINER

  7. Remove the front differential assembly while being careful not to damage the attachment part of the retainer.
About FixVault