FixVault
Home › Subaru › 2010 › Outback R › Repair and Diagnosis › Body & Frame › Door Locks › Anti-Theft System - Security And Locks › Ignition Key Lock › Inspection

Ignition Key Lock: Inspection

  1. Disconnect the ignition switch connector.
  2. Measure the resistance between ignition switch terminals.

    Preparation tool: Circuit tester 

    Fig 1: Measuring Resistance Between Ignition Switch Terminals
    G06653928Courtesy of SUBARU OF AMERICA, INC.
    TERMINAL REFERENCE

    Terminal No. Inspection Conditions Specification
    - LOCK -
    3 - 5 ACC Less than 1 Ω
    3-1,4
    3 - 5    		 ON Less than 1 Ω
    3 - 2,6
    3 - 1,4    		 ST Less than 1 Ω
  3. Replace the ignition switch if the inspection result is not within the standard value.
About FixVault