Drive Plate: Installation

WARNING: This page is about a different car, the 2012 Subaru Outback and 2012 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

Temporarily tighten the drive plate.
Set the ST.
ST 498497100 CRANKSHAFT STOPPER

Fig 1: Identifying Crankshaft Stopper With Transmission Assembly (View 2 Of 2)
Courtesy of SUBARU OF AMERICA, INC.
Tighten the drive plate mounting bolt in three stages.
NOTE: Fix the engine unit.
1. Tighten the drive plate mounting bolt.
  Tightening torque:
  
  10 N.m (1.0 kgf-m, 7.4 ft-lb)
2. Additionally tighten the drive plate mounting bolts.
  Tightening torque:
  
  40 N.m (4.1 kgf-m, 29.5 ft-lb)
3. While checking the tightening angle with the ST, tighten the drive plate mounting bolts to the specified angle.
  Tightening angle:
  
  30°±5°
  
  ST 18854AA000 ANGLE GAUGE
Install the transmission assembly to the vehicle. Refer to , INSTALLATION , Automatic Transmission Assembly.