Primary Speed Sensor: Installation
WARNING: This page is about a different car, the 2012 Subaru Outback and 2012 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Be sure to prevent water or oil from contacting the connector terminal of primary speed sensor. If adhesion occurs, replace with a new part.
Install in the reverse order of removal.
NOTE:
- Use new O-rings.
- Apply CVTF to the O-ring.
Tightening torque:
5 N.m (0.5 kgf-m, 3.7 ft-lb)