Secondary Pressure Sensor: Installation
WARNING: This page is about a different car, the 2012 Subaru Outback and 2012 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- Be sure to prevent water or oil from contacting the connector terminal of secondary pressure sensor. If adhesion occurs, replace with a new part.
- After installing the secondary pressure sensor, adjust the CVTF level.
Install in the reverse order of removal.
NOTE:
Use new O-rings.
Tightening torque:
39 N.m (4.0 kgf-m, 28.8 ft-lb)