Engine Control Module (ECM): Installation

Install in the reverse order of removal.

CAUTION:

When the ECM of model with immobilizer has been replaced, be sure to perform the registration of immobilizer system. (Refer to "PC application help for Subaru Select Monitor".)
When replacing the ECM or the bracket, replace both parts with the new ones.
After attaching the bracket to the ECM, do not detach the bracket.
If the bracket is attached to the ECM in the wrong direction, replace both parts with the new ones.
When the ECM has been replaced, be sure to perform registration of VIN. Refer to OPERATION .

NOTE: When replacing the ECM, be careful not to use the wrong spec. ECM to avoid any damage on the fuel injection system.

Tightening torque:

7.5 N.m (0.8 kgf-m, 5.5 ft-lb)