Knock Sensor: Installation

Install the knock sensor to the cylinder block.
NOTE: Extraction area of knock sensor cord must be positioned at a 60° angle relative to the engine rear.

Tightening torque:

24 N.m (2.4 kgf-m, 17.7 ft-lb)

Fig 1: Positioning Extraction Area Of Knock Sensor Cord At 60° Angle Relative To Engine Rear
Courtesy of SUBARU OF AMERICA, INC.
Connect the knock sensor connector.

Fig 2: Identifying Knock Sensor Connector
Courtesy of SUBARU OF AMERICA, INC.
Install the air intake chamber. < Ref. to INSTALLATION , Air Intake Chamber. >
Connect the battery ground terminal.

Fig 3: Connecting Ground Cable From Battery
Courtesy of SUBARU OF AMERICA, INC.