Engine Mounting: Installation

Set the engine mounting, and tighten the bolts which hold engine mounting to the engine.
Tightening torque:

58 N.m (5.9 kgf-m, 42.8 ft-lb)

Fig 1: Locating Engine Mounting Bolts
Courtesy of SUBARU OF AMERICA, INC.
Lower the vehicle.
CAUTION: When lifting down the vehicle, lower wire ropes at the same time.
Attach the bolts and nuts which secure engine mounting to the cradle.
Tightening torque:

60 N.m (6.1 kgf-m, 44.3 ft-lb)

Fig 2: Locating Engine Mounting Cradle Bolts And Nuts
Courtesy of SUBARU OF AMERICA, INC.
Install the stopper rod.
Tightening torque:

36 N.m (3.7 kgf-m, 26.6 ft-lb)

Fig 3: Identifying Stopper Rod
Courtesy of SUBARU OF AMERICA, INC.
Remove the lifting device and wire ropes.

Fig 4: Supporting Engine With Lifting Device And Wire Ropes
Courtesy of SUBARU OF AMERICA, INC.
Lift up the vehicle.
Install the front exhaust pipe. < Ref. to EX(H4SO)-5, INSTALLATION, Front Exhaust Pipe.>
Install the under cover. < Ref. to EI-35, INSTALLATION, Front Under Cover.>
Lower the vehicle.
Install the radiator main fan motor assembly and radiator sub fan motor assembly. < Ref. to CO(H4SO)-23, INSTALLATION, Radiator Main Fan and Fan Motor. > < Ref. to CO(H4SO)-24, INSTALLATION, Radiator Sub Fan and Fan Motor.>
Connect the ground cable to battery.

Fig 5: Connecting Battery Ground Cable
Courtesy of SUBARU OF AMERICA, INC.
Change the front hood damper mounting position from (B) to (A), and close the front hood.
Tightening torque:

20 N.m (2.0 kgf-m, 14.8 ft-lb)

Fig 6: Identifying Front Hood Damper Mounting Position
Courtesy of SUBARU OF AMERICA, INC.