Front ABS Wheel Speed Sensor: Installation

WARNING: This page is about a different car, the 2012 Subaru Outback and 2012 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Be careful not to damage the sensor.

Install each part in the reverse order of removal.

NOTE:

Check the identification (mark) on the harness to make sure there is no warpage. Refer to , SPECIFICATION , General Description.
Check if the harness is not pulled and does not come in contact with the suspension or body while operating the steering.

Tightening torque:

Front ABS wheel speed sensor: 7.5 N.m (0.76 kgf-m, 5.5 ft-lb)