FixVault
Home › Subaru › 2011 › Outback R › Repair and Diagnosis › External Pages › Different car › Section 73 (Fuel Injection Fuel Systems (H4SO)) › Intake Manifold › Installation › Multi-Function Duct Assembly

Multi-Function Duct Assembly

WARNING: This page is about a different car, the 2012 Subaru Outback and 2012 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal.

NOTE:
  • Use a new gasket.
  • The oil pressure switch harness must be positioned to be within the range of a 45° angle on either left or right toward the rear of the vehicle.

Tightening torque: 

1.5 N.m (0.2 kgf-m, 1.1 ft-lb) 

Fig 1: Identifying Oil Pressure Switch Harness Installation Angle
G07909653Courtesy of SUBARU OF AMERICA, INC.

Tightening torque: 

6.4 N.m (0.7 kgf-m, 4.7 ft-lb) 

Fig 2: Locating Multi-Function Duct Assembly Bolts (1 Of 2)
G06648278Courtesy of SUBARU OF AMERICA, INC.
Fig 3: Locating Multi-Function Duct Assembly Bolts (2 Of 2)
G06648280Courtesy of SUBARU OF AMERICA, INC.

Tightening torque: 

19 N.m (1.9 kgf-m, 14.0 ft-lb) 

Fig 4: Locating Ground Terminal Bolt
G06648279Courtesy of SUBARU OF AMERICA, INC.
About FixVault