Knock Sensor: Installation

WARNING: This page is about a different car, the 2012 Subaru Outback and 2012 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

Install the knock sensor to the cylinder block.
NOTE: The portion of the knock sensor cord that is pulled out must be positioned at a 60° angle relative to the engine rear.

Tightening torque:

24 N.m (2.4 kgf-m, 17.7 ft-lb)

Fig 1: Identifying Knock Sensor Cord Angle
Courtesy of SUBARU OF AMERICA, INC.
Connect the knock sensor connector.

Fig 2: Locating Knock Sensor Connector
Courtesy of SUBARU OF AMERICA, INC.
Install the air intake boot assembly. Refer to AIR INTAKE BOOT .
Connect the ground cable to battery.

Fig 3: Connecting Ground Cable To Battery

Courtesy of SUBARU OF AMERICA, INC.