FixVault
Home › Subaru › 2011 › Outback R › Repair and Diagnosis › External Pages › Different car › Section 83 (Automatic Transmission) › Front Differential Assembly › Installation

Front Differential Assembly: Installation

WARNING: This page is about a different car, the 2012 Subaru Outback and 2012 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. When installing the front differential assembly to the case, be careful not to damage the inside of case (particularly, the differential side retainer mating surface).
    Fig 1: Identifying Front Differential Assembly
    G07914895Courtesy of SUBARU OF AMERICA, INC.
  2. Install the O-ring to left and right side retainers.
  3. Using the ST, install the side retainer. Refer to , ADJUSTMENT , Front Differential Assembly.

    ST 18630AA010 WRENCH COMPL RETAINER

  4. Adjust the backlash of the front differential. Refer to , ADJUSTMENT , Front Differential Assembly.
  5. Install the lock plate.

    Tightening torque: 

    25 N.m (2.5 kgf-m, 18.4 ft-lb) 

    Fig 2: Identifying Lock Plate
    G07914896Courtesy of SUBARU OF AMERICA, INC.
  6. Install the converter case to the transmission case. Refer to , INSTALLATION , Converter Case.
  7. Install the transmission harness connector to the stay.
  8. Install the ATF cooler pipe. Refer to , INSTALLATION , ATF Cooler Pipe and Hose.
  9. Install the torque converter assembly. Refer to , INSTALLATION , Torque Converter Assembly.
  10. Install the transmission assembly to the vehicle. Refer to , INSTALLATION , Automatic Transmission Assembly.
About FixVault