Brake Pedal: Installation
WARNING: This page is about a different car, the 2012 Subaru Outback and 2012 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
- Install each part in the reverse order of removal.CAUTION:
- Apply grease to the snap pin to prevent the operating rod from wear.
- Replace the clevis pin with new parts, and apply thin coat of NIGTIGHT LYW No. 2 grease to the clevis pin.
Tightening torque:
Brake pedal: 18 N.m (1.84 kgf-m, 13.3 ft-lb)
- Check that the brake light operate properly.
- Check the brake pedal after installation. Refer to , INSPECTION , Brake Pedal.