Fuel Sub Level Sensor: Installation

Install in the reverse order of removal while being careful of the following.

Make sure the sealing portion is free from fuel or foreign matter before installation.
Align protrusion (A) of the gasket to the position shown in the following figure.
Align protrusion of the fuel sub level sensor to the cutout in the fuel sub level sensor upper plate.
Tighten the nuts and bolts to the specified torque in the order as shown in the figure.

NOTE: Use a new gasket.

Tightening torque:

4.4 N.m (0.4 kgf-m, 3.2 ft-lb)

Fig 1: Identifying Gasket Protrusion Position With Torque Sequence

Courtesy of SUBARU OF AMERICA, INC.

Fig 2: Fuel Sub Level Sensor Nuts

Courtesy of SUBARU OF AMERICA, INC.