FixVault

Read Freeze Frame Data For Engine (OBD Mode)

NOTE:
  • For detailed operation procedures, refer to "PC application help for Subaru Select Monitor".
  • A list of the support data is shown in the following table.
Contents Display Unit of measure
DTC of freeze frame data Freeze frame data -
Air fuel ratio control system for bank 1 Fuel system for Bank 1 -
Engine load data Calculated load value %
Engine coolant temperature signal Coolant Temp. °C or °F
Short term fuel trim by front oxygen (A/F) sensor (Bank 1) Short term fuel trim B1 %
Long term fuel trim by front oxygen (A/F) sensor (Bank 1) Long term fuel trim B1 %
Intake manifold absolute pressure signal Mani. Absolute Pressure mmHg, kPa, inHg or psi
Engine speed signal Engine Speed rpm
Vehicle speed signal Vehicle Speed km/h or MPH
Ignition timing adv. #1 Ignition timing adv. #1 °
Intake air temperature Intake Air Temp. °C
Amount of intake air Mass Air Flow g/s
Throttle valve angle Throttle Opening Angle %
Oxygen sensor #12 Oxygen sensor #12 V
A/F correction #12 Short term fuel trim #12 %
OBD system OBD System -
Oxygen sensor #11 Oxygen sensor #11 -
Oxygen sensor #12 Oxygen sensor #12 -
Elapsed time after starting engine Time Since Engine Start sec
Evaporative purge Commanded Evap Purge %
Fuel level Fuel Level %
Fuel tank pressure Fuel Tank Pressure mmHg, kPa, inHg or psig
Atmospheric pressure Atmosphere Pressure mmHg, kPa, inHg or psig
ECM power supply voltage Control module voltage V
Absolute load Absolute Load Value %
A/F target lambda Target Equivalence Ratio -
Relative throttle opening angle Relative Throttle Pos. %
Ambient temperature Ambient Temperature °C or °F
Absolute throttle opening angle 2 Absolute Throttle Pos.#2 %
Absolute accelerator opening angle 1 Accelerator Pedal Pos.#1 %
Absolute accelerator opening angle 2 Accelerator Pedal Pos.#2 %
Target throttle opening angle Target Throt. Act. Cont. %
Neutral condition MT gear status -