Force Sensor Calibration Mode

CAUTION:

Subaru Select Monitor is required for the Force Sensor Calibration Mode.
Make sure to perform this procedure with the vehicle parked in a horizontal place and to use wheel chocks.

NOTE:

When the following work is performed, use this function to perform calibration of force sensor in the parking brake actuator.
- Removing the parking brake assembly
- Replacing the electronic parking brake control module
- Adjusting the shoe clearance
After replacing the electronic parking brake control module, if the calibration of the force sensor has not yet been performed, the brake warning light will blink and "Force Sensor Line (abnormal)" DTC will be detected.

Park the vehicle in a horizontal place using wheel chocks.
Connect the Subaru Select Monitor.
On << Main Menu >> display, select {Each System Check}.
On << System Selection Menu >> display, select {Brake Control System}.
Click the [OK] button after {Parking Brake System} is displayed.
On << Maintenance Operation Mode >> display, select {Force Sensor Calibration Mode}.
The confirmation screen of vehicle parking condition and wheel chocks usage is displayed. Confirm the parking condition and wheel chocks, and click the [YES] button.
A message indicating the calibration mode in progress is displayed on the screen, and the Force Sensor Calibration Mode begins.
The message, "Force sensor calibration done. Turn Ignition Switch OFF.", is displayed on the screen. Turn the ignition switch to OFF to end the calibration mode.