Check Turn Signal And Hazard Module

Measure the voltage between turn signal & hazard module connector and chassis ground.

Preparation tool: Circuit tester Connector

Terminal No.	Input/Output	Inspection conditions	Standard
6 ↔ Chassis ground	Input	Turn signal switch (Right) OFF → ON	9 V or more → less than 1 V
5 ↔ Chassis ground	Input	Turn signal switch (Left) OFF → ON	9 V or more → less than 1 V
8 ↔ Chassis ground	Input	Hazard switch OFF → ON	9 V or more → less than 1 V
2 ↔ Chassis ground	Output	Turn signal switch (Right) OFF → ON	Repeat less than 1 V → less than 1 V ↔ more than 9 V at 60 to 120 times per minute.
3 ↔ Chassis ground	Output	Turn signal switch (Left) OFF → ON	Repeat less than 1 V → less than 1 V ↔ more than 9 V at 60 to 120 times per minute.
2 ↔ Chassis ground	Output	Hazard switch OFF → ON	Repeat less than 1 V → less than 1 V ↔ more than 9 V at 60 to 120 times per minute.
3 ↔ Chassis ground	Output	Hazard switch OFF → ON	Repeat less than 1 V → less than 1 V ↔ more than 9 V at 60 to 120 times per minute.

Replace the turn signal and hazard module if the inspection result is not within the standard value.