FixVault
Home › Subaru › 2012 › Outback Base, Standard Trans › Repair and Diagnosis › Engine Performance › System › Engine Diagnostics (H4SO) › Drive Cycle › Procedure › Preparation For Drive Cycle

Preparation For Drive Cycle

  1. Check that the battery voltage is 12 V or more and fuel remains approx. half [20 - 40 l  (5.3 - 10.6 US gal, 4.4 - 8.8 Imp gal)].
  2. After performing the diagnostics and Clear Memory Mode, check that no DTC remains. Refer to , CLEAR MEMORY MODE .
  3. Check the delivery (test) mode fuse is removed.
NOTE:
  • Perform the drive cycle after warming up the engine except when the engine coolant temperature at engine start is specified.
  • Perform the drive cycle twice if the DTC in the list is marked with *. After completing the first drive cycle, stop the engine and perform second diagnosis in same condition.
About FixVault