Malfunction Indicator Light Does Not Blink: Wiring Diagram

Fig 1: Malfunction Indicator Light Wiring Diagram (Delivery Test Mode Fuse Circuit Open)

Courtesy of SUBARU OF AMERICA, INC.

Step	Check	Yes	No
1 CHECK STATUS OF MALFUNCTION INDICATOR LIGHT.  Turn the ignition switch to OFF. Check the delivery (test) mode fuse is removed. Turn the ignition switch to ON. (engine OFF)	Does the malfunction indicator light illuminate?	Go to step 2.	Repair the malfunction indicator light circuit. Refer to , MALFUNCTION INDICATOR LIGHT DOES NOT COME ON , Malfunction Indicator Light.
2 CHECK VEHICLE SPECIFICATION	Is the vehicle except for C6 model?	Go to step 4	Go to step 3
2 CHECK HARNESS BETWEEN ECM AND COMBINATION METER CONNECTOR.  Turn the ignition switch to OFF. Disconnect the connectors from ECM. Turn the ignition switch to ON.	Does the malfunction indicator light illuminate?	Repair the ground short circuit of harness between ECM and combination meter connector.	Go to step 4
3 CHECK HARNESS BETWEEN ECM AND DELIVERY (TEST) MODE FUSE.  Turn the ignition switch to OFF. Install the delivery (test) mode fuse of the main fuse box. Measure the resistance of harness between ECM connectors. Connector & terminal  (B136) No. 34 - (B136) No. 4:	Is the resistance less than 1 Ω?	Go to step 5	Repair the harness and connector. NOTE: In this case, repair the following item: Open circuit of harness between ECM and delivery (test) mode fuse Poor contact of joint connector
4 CHECK FOR POOR CONTACT.  Check for poor contact of ECM connector.	Is there poor contact of ECM connector?	Repair the poor contact of ECM connector.	Replace the ECM. Refer to ENGINE CONTROL MODULE (ECM) Engine Control Module (ECM).