FixVault
Home › Subaru › 2012 › Outback Base, Standard Trans › Repair and Diagnosis › External Pages › Different car › Section 45 (Anti-Theft System - Security And Locks) › Keyless Entry Control Module › Removal

Keyless Entry Control Module: Removal

WARNING: This page is about a different car, the 2011 Subaru Tribeca. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the ground cable from battery.
  2. Remove the glove box. Refer to GLOVE BOX REMOVAL, Glove Box.
  3. Remove the nut, disconnect the connector and remove the keyless entry control module.
Fig 1: Locating Keyless Entry Control Module Connector Nut
G05033666Courtesy of SUBARU OF AMERICA, INC.
About FixVault